AFM

Earthpaint

Looking Glass Polish

Features
No Petrochemicals
Water Repelling
Easy to Use
Sustainable Wood Petrification Technology
No Offensive Odors
Will not peel or flake off like polyurethane
Locally harvested ingredients
Low VOC, Non-Toxic
No expensive Stripping for future coats

General Properties
Interior grade, durable non-film forming, satin finish, penetrating, clear, high solids oil & wax with water repellency, and grain illumination. Hardens into wood fibers.

Locally Harvested Ingredients
100% pure Bees Wax, Flax oil, Air Oxidized Linseed Oil, Safflower Oil, Citrus distillate, Pine Tree Ester, Essential Oil of Peppermint, Lead free Mineral Salt Driers.

Recommended For
Finishing wax for Interior wood, Trim, cabinets, doors, floors, furniture, paneling. Masonry: As a water repellant sealer for lime based plasters, clay plasters, gypsum plasters, concrete block, stucco, concrete countertops, concrete floors.

Technical Data

Pigment Type: None, inherent amber tone of plant oil.
Volume Solids: 98.99%
Dry time @ 77F (25C) @ 50% R.H.:
Set to Touch: 2 hours
To Recoat: 12 Hours
To Service: 24 to 48 hours (Allow at least 48 hours from final coat before normal floor traffic.)
Clean up: Soap and water, dry rag or Earthpaint Pure Citrus Solvent.
Shelf Life: 1 year

Surface preparation
Remove all previous coatings to insure full, raw wood impregnation, and surface appearance. Sand all wood bare, with the grain, to the desired level of smoothness. Sanding is unavoidable for fine finishing results. Start with coarse grit and move to finer grit sandpaper ending with a final sanding of 400 grit.

All surfaces must be dry, sanded smooth, free of dirt, dust or grit. All nail holes, cracks and blemishes should be repaired after first application if possible and filled in with a filler that matches the wood color. Melting Saw dust from the wood to be filled, into this product is a natural way of making strong wood filler that blends into the wood effectively.

Application
One Application: Rub into surface with a clean lint free cloth, lambswood pad or sponge. Wipe off excess with dry rag immediately or within on hour.

Wipe on a second, thin coat. Wipe off excess within one hour. (This second coat uses minimal product, takes little time and results in a longer lasting finish.)

Applying Warm: A warm application is a master wood worker secret. Warming the wax and the surface is even more effective. However, simply placing Looking Glass Polish in the oven, slow cooker or a double boiler until it reaches 150&Mac251; F will allow the wax to melt. (Warning: Hot wax will burn skin, eyes and lungs if contacted. Wear protective clothing.)

Recoating: Do not strip. Simply clean and recoat within five years to build upon the petrification effect.

BACK TO TOP